index-table-line-v1: playback
Flat views of the same data as this line's FreeCAD model, played over the line's cycle. This page is not the model: it shows only what the model's data holds, each part's outline placed as the model places it, with no shading or perspective; nearer parts are painted over farther ones.
From the front (the line runs left to right; up is up)
At a slant, parts are painted by the depth of their middles; where a long part and a short one overlap closely, the order can be wrong.
From above (the line runs left to right; up the page is away from the front)
At a slant, parts are painted by the depth of their middles; where a long part and a short one overlap closely, the order can be wrong.
The brief's zones
A zone isgreen while it is met,red while the part is in it but it is not met, andgrey otherwise, as in the FreeCAD model. The zones show position, angle and holds for the nominal design. The mean position tolerance, a monotone carry between targets, the carry's level and straightness, dynamics limits, pressure and transmission angles, and robustness on mis-built copies are not shown: see the report of the design.
What a view leaves out
- Each pane can be turned to the line's front, back, either end, above or below, on the same clock. From an end the stations stand one behind another, nearer painted over farther; with Go to, an end view draws that station alone (its rigs and brief too), which shows its timing.
- Four views look from above at a corner, at a slant. There a part with cuts is drawn as its face, every cut on its depth taken out, carried through its depth: slots and holes are seen through where they would be.
- A part seen face on shows its true outline, with the holes that run right through it (a blind hole or a counterbore is not drawn); seen edge on, the outline of its whole depth; a round part is drawn with 72 sides.
- No hidden lines are removed beyond painting nearer parts over farther ones; there is no shading or perspective. Parts that do not move (plates, posts, rails) are drawn see-through, so what moves behind them shows.
- A barrel's drum turns in place, so its outline does not change: its turn shows in its groove and its follower.
- A traced point's whole path, drawn faintly, joins the point's places at its station's stored samples with straight lines; its trail is those it has passed since the cycle began, then where it is now.
- Anything the model's data does not hold (fasteners, a gear's teeth) is not drawn here either.